Table of Contents
Below are details and instructions on removing and installing linxCam SD cards.
NOTE: It is strongly NOT RECOMMENDED that customers purchase their own SD cards. Purchasing through Linxup includes testing and support. Customer-supplied SD cards are not supported and may not function properly.
Upgrading Your linxCam SD Cards
Default SD Cards |
~ 80 hours of drive time footage SD Card 1: 256 GB SD Card 2: 128 GB |
Upgrade Kit |
~ 160 hours of drive time footage SD Card 1: 512 GB SD Card 2: 256 GB |
NOTE: The upgrade kit includes 2 SD cards, the primary and secondary cards.
The estimated hours of video available may vary significantly, depending on several factors, and should be considered an approximation.
Removing SD Cards
To remove the SD cards, PUSH the card in to unlatch the card and then walk the card out slowly.
NOTE: The SD card container is spring loaded.
 |
 |
 |
 |
Installing SD Cards
NOTE: The Primary High Res SD card goes in spot 1 and the Secondary Low Res SD card goes in spot 2.
Installing SD Cards in linxCam Version 1
For linxCam version 1, contacts on the SD cards should face each other, meaning the upper card contacts face down, and the lower card contacts face up. Orient the SD card properly so that the contacts are facing down (slot 1) or up (slot 2) and slowly insert until you feel resistance. Then push the card in until the latch catches. There will be an audible click.
|
|
Installing SD Cards in linxCam Version 2
For linxCam version 2, contacts on the SD cards should both face down. Orient the SD cards properly so that the contacts are facing down and slowly insert until you feel resistance. Then push the card in until the latch catches. There will be an audible click.
|
|