Table of Contents
Below are the installation instructions for your device.
To view the device on your portal, please ensure to activate your device.
 |
Video Walkthrough |
How to Install AT3 Tracker
Installing Your Wired Asset Tracker
You have purchased a wired asset tracker device which contains an internal rechargeable battery. This battery may not be fully charged when you first receive it. In order to bring this device online, please either charge the asset tracker device for a minimum of four hours, or wire the device for installation to an appropriate power source.
***IMPORTANT*** - There are two versions of AT3 hardware. Although they differ slightly in appearance, there is no difference in quality or functionality. To best identify which version you have, check the device serial number. The serial number will start with either an XT or a 68W.
- Connect the device according to the equipment power setup as detailed below.
|
Non-Powered Asset |
For Non-Powered Assets
|
 Powered Assets |
For Powered Assets(NOTE: this is REQUIRED for Mower Tracker.)
|
NOTE: Unused wires should be taped out of the way and prevented from making contact with anything metal.
- Confirm the Power Connection
- Following installation, allow 5-10 minutes for the Linxup asset tracker to power up and obtain a cellular and GPS fix.
- Your asset must be outside and not in a covered area so that it will receive GPS signal. Once you have LED confirmation of power, your installation is complete.
For XT models:
|
Blue
|
Green
|
For 68W models:
|
Red
|
Green
|
- Installation for Most PTO Applications
- Locate and connect the unpowered side of the control switch for the equipment being monitored.
- Connect the yellow wire to the correct terminal on your automotive relay.
- Connect the two remaining terminals on your relay to ground.
NOTE: If PTO is going to be used, the AT3 needs to be wired red to constant and white to switched ignition.
Install Positioning Matters
Not intended for use:
- Indoors
- Inside of metal casings
- Underground
- In remote “no cell coverage” areas
Performance and results will vary if used in the above environments.
That's it! You're ready to start tracking.
Now it's time to start customizing your account. Visit our features section to learn how to set up users, geofences, alerts, and more.