Table of Contents
Below are the installation instructions for your device.
To view the device on your portal, please ensure to activate your device.
Installing Your Solar Asset Tracker
- Your solar tracker is set to shipping mode to preserve the battery. Before use, hold down the black button on the side until you see a light.
- The Linxup solar asset tracker can be attached to your equipment with magnets or by using 10-24 x 1 sized screws (not included). ATSolar devices should be mounted on a flat surface.
NOTE: Do not over tighten and do not bend the device. Do not use glue or other drying adhesives; they can block a small vent on the back of the tracker. Make sure it is installed in a location that has access to sunlight.
Install Positioning Matters
Not intended for use:
- Indoors
- Inside of metal casings
- Underground
- In remote “no cell coverage” areas
Performance and results will vary if used in the above environments.
That's it! You're ready to start tracking.
Now it's time to start customizing your account. Visit our features section to learn how to set up users, geofences, alerts, and more.